Damark

For convenience and safety reasons the B24/B34-MP sleeve wrappers are shipped fully assembled. Take caution when unloading and uncrating. 

For a guide on unloading and uncrating your machine read this article: 

Unpacking a B-MP Machine

It can happen that seal-wire can warp or break due to overheating. To learn how to correct seal-wire breakage check out this article,

Seal Wire Breakage

It is normal for the seal wire of an L-Bar Sealer to become contaminated with film over time with continued use. If you need to clean the build of plastic on the seal wire follow the steps in this article:

Cleaning L-Bar Seal Wire

To learn how to change the seal wire in an L-Bar Sealer you can check out this help article

How to Change the Sealing Wire in an L-Bar Sealer 

Routine cleaning is important in maintaining the correct function of your machine and will extend the longevity of your equipment. Depending on your production environment your machine may require more or less cleaning. Generally, your machine should be cleaned once every two weeks and the seal wire or hot knife should be cleaned daily

To clean your machine simply wipe down with a clean cloth using water and light liquid detergent. Do not use any corrosive solvents. Do not expose machine to "washdown" procedure. Do not expose internal components to liquids of any kind. 

If you are noticing that your L-Bar sealer is producing uneven or bad seals, check these parts:

• Are your seal wires broken or worn?
• Does the telon tape need to be replaced?
• Is the silicon sealing base worn?
• Is the sealing pressure uneven?

If you are finding your conveyor is not tracking on your L-Bar sealer the conveyor alignment may be off. While we run all our machines and verify conveyor tracking before sending them out, it is advisable to always verify conveyor tracking after installation. 

Learn how to correct conveyor tracking:

Conveyor Tracking on L-Bar Sealer

It can happen that seal-wire can warp or break due to overheating. To learn how to correct seal-wire breakage check out this article,

Seal Wire Breakage

Routine cleaning is important in maintaining the correct function of your machine and will extend the longevity of your equipment. Depending on your production environment your machine may require more or less cleaning. Generally, your machine should be cleaned once every two weeks and the seal wire or hot knife should be cleaned daily

To clean your machine simply wipe down with a clean cloth using water and light liquid detergent. Do not use any corrosive solvents. Do not expose machine to "washdown" procedure. Do not expose internal components to liquids of any kind. 

Prior to shipping from the factory, your MP Series machine was operated for a minimum of four hours to check the tracking of the conveyor belt. It is advisable, particularly when you have just installed your new unit, to carefully watch the conveyor belt to make sure the tracking is maintained.

Conveyor Tracking for MP Combo Systems